5C collet set from the last Clausing lathe I bought. Only use 3 of the collets with my setup so the rest is for sale. 31 collets by 32nds from 1/16" to 1 1/16". Missing are 5/32", 3/8" and 1/2". There are no names on the collets or the closer
Spin type closer. It all works fine and was installed when I bought the lathe. ( I actually bought this from a blind machinist. He has calipers that called out the sizes so he could measure things. Somehow he talked the local college into accepting him as a student, was going to take them to court for discrimination if they did not. Still had all his fingers and was a good machinist when I met him, somehow good enough to even make repairs on the machines in his shop. )
$250.00 or best offer. Don't know what the shipping weight would be but I will ship without the board if you want to make your own.
Bob Danielson
www.bdcuesandcomix.com
Spin type closer. It all works fine and was installed when I bought the lathe. ( I actually bought this from a blind machinist. He has calipers that called out the sizes so he could measure things. Somehow he talked the local college into accepting him as a student, was going to take them to court for discrimination if they did not. Still had all his fingers and was a good machinist when I met him, somehow good enough to even make repairs on the machines in his shop. )
$250.00 or best offer. Don't know what the shipping weight would be but I will ship without the board if you want to make your own.
Bob Danielson
www.bdcuesandcomix.com
