almost finished...OOPS

[Newton]

I ground some flat spots on the bearing casing were each post contacts it. That stops most movement, but sometimes the bearing will pop out when a cue gets stuck in a collet and I have to push hard to release it.
Overall, it works pretty good considering. It does take longer to setup a cue to run true as there is a little play on the base of the steady rest.
Dave

Thanks Dave,

I was considering to make a all new steady where the ballbearing was made
to fit, but then I thought that it would be hard to make that 100% alined.

I'll have a go at it on my own machine then

Kent