another mid-cue extension question

[evergruven]

it seems obvious, but I'm also having trouble picturing it
if the cue is conical to begin with, is it possible to make a mid-cue extension that fits into the cone?

 

[billsey]

A mid-cue extension is going to be a cylinder, not a cone, since both ends have to match the size of the original joint.

 

[evergruven]

A mid-cue extension is going to be a cylinder, not a cone, since both ends have to match the size of the original joint.

ah, thanks bill- that makes sense.

 

[Quesports]

I have been after one for a Bender cue. Now considering removing the pin of a balance rite extension and reinstalling the Bender pin then retapping the female end. It is a chore but may be my only option.

 

[Michael Webb]

I have been after one for a Bender cue. Now considering removing the pin of a balance rite extension and reinstalling the Bender pin then retapping the female end. It is a chore but may be my only option.

That will work but The joint size will be different unless you find one with a .850 to .855

 

[Quesports]

That will work but The joint size will be different unless you find one with a .850 to .855

No problem on that. I could care less if it is off somewhat. Plus I refinish all my own cues with auto clear coat and can build it then sand it down after to be exact if I feel like it. Really does not bother me a bit if it is not perfect and does not affect playability... IMO!

 

[Quesports]

I have given up. Multiple attempts using all the contact means I could find. I got NO reply from Mike Bender.

THAT'S ALL FOLKS !!#!