Anyone have a measurement for lucasi?

[PracticeChampion]

Got request to build a shaft and the ring work to match the butt, sure no problem but he's few hours away so I can't measure. Anyone have a measurement on the ring work

 

[PracticeChampion]

Bump

 

[Ģüśţāṿ]

I have an old lucasi flexpoint shaft with the triple rings. What dimensions do you want specifically? I could measure it for you, or just hold a finely graduated ruler up to it for spacing. Let me know what you need.

 

[PracticeChampion]

I have an old lucasi flexpoint shaft with the triple rings. What dimensions do you want specifically? I could measure it for you, or just hold a finely graduated ruler up to it for spacing. Let me know what you need.

Measurement of joint collar overall top to bottom and distance between all rings best you can.

 

[Ģüśţāṿ]

Joint diameter = .840
Top ring thickness( towards tip ) = .120
Bottom ring ( at joint ) = .100
Silver rings = .025
Between rings = .040
Total stack = .375

In your photo it looks like the top and bottom rings may be a similar thickness, but mine are not.

 

[PracticeChampion]

Joint diameter = .840
Top ring thickness( towards tip ) = .120
Bottom ring ( at joint ) = .100
Silver rings = .025
Between rings = .040
Total stack = .375

In your photo it looks like the top and bottom rings may be a similar thickness, but mine are not.

Awesome... Thank you much!!! I'll put your numbers together and see how it looks

 

[PracticeChampion]

Joint diameter = .840
Top ring thickness( towards tip ) = .120
Bottom ring ( at joint ) = .100
Silver rings = .025
Between rings = .040
Total stack = .375

In your photo it looks like the top and bottom rings may be a similar thickness, but mine are not.

I guess I shoulda asked from the get go. Is yours a uni-loc? If so can you measure how much of the brass insert sticks out and the diameter. I did screw it onto another lucasi butt so maybe there all the same I don't know