Anyone use...
- Thread starter PrimoCues
- Start date
I have one.
Bad, you are stuck with the shaft taper it comes with. You can hand dial it and manually back off or go in with the cutter if you want.
Or have a bar made for your taper.
The dial does not have true numbers on them. Meaning if you want to take 20 thou, you have hit 3 dots plus about a third of a dot. I've installed a dial indicator for it to get as accurate as possible.
Good, it's fairly small and quiet. Easy to box in to trap the chips.
You can make rings with it, or cut points.
It doesn't crash unless you are really careless or dumb or lazy.
A good machine. I dunno of another one that is better than it for the price and size.
Bad, you are stuck with the shaft taper it comes with. You can hand dial it and manually back off or go in with the cutter if you want.
Or have a bar made for your taper.
The dial does not have true numbers on them. Meaning if you want to take 20 thou, you have hit 3 dots plus about a third of a dot. I've installed a dial indicator for it to get as accurate as possible.
Good, it's fairly small and quiet. Easy to box in to trap the chips.
You can make rings with it, or cut points.
It doesn't crash unless you are really careless or dumb or lazy.
A good machine. I dunno of another one that is better than it for the price and size.