atlas lathe and bridgeport head on drill press table

J

Jlkjr21

Registered
i have a 10 x 22 atlas lathe with 6 jaw chuck. it also has an indexer so you can probly use to but points and do other work. it has a gear with one broken tooth but the machine still works fine and the power feed works. its a 110v. Make offer

i also have a bridgeport "m" milling head mounted on a drill press table with an indexer mounted to a compound and then mounted to the table. it could be used to make trim rings and such. Forgot to say its 3 phase and will need an inverter. Make offer

please ask any questions i will try to answer them to the best of my knowledge or send more photos. this equipment is located in new orleans.
 

Attachments

  • 1.JPG
    1.JPG
    41.7 KB · Views: 1,312
  • 2.JPG
    2.JPG
    45.5 KB · Views: 1,379
  • 3.JPG
    3.JPG
    45.4 KB · Views: 2,486
  • 4.JPG
    4.JPG
    49.9 KB · Views: 1,221
  • 5.JPG
    5.JPG
    44.7 KB · Views: 1,153
Last edited:
Any questions about anything? I am open to any offers. I recently bought a large lathe and cnc router and need room. These machines have to go.
 
You must log in or register to reply here.
Back
Top