Azb mechanics-thank you

[3RAILKICK]

:thumbup:for answering so many questions for us. Me and we appreciate it(speaking for sure for me).

I'm putting a GCII together and have had many questions. Special thanks to mechanic Donny Wessel/sd billiards and to Ken Hash of classicbilliards.

Thanks again to all the table mechanics who post here. a special shoutout to RKC, but not to the exclusion of the many highly skilled mechanics who put up with our questions, and take the time to answer and educate us.

Gentlemen-thank you.

 

[Donny Wessels]

:thumbup:for answering so many questions for us. Me and we appreciate it(speaking for sure for me).

I'm putting a GCII together and have had many questions. Special thanks to mechanic Donny Wessel/sd billiards and to Ken Hash of classicbilliards.

Thanks again to all the table mechanics who post here. a special shoutout to RKC, but not to the exclusion of the many highly skilled mechanics who put up with our questions, and take the time to answer and educate us.

Gentlemen-thank you.

Your table is going to be a blast to work on. Joe stopped by and showed me some of the powder coating samples and was telling me about the color scheme. Looking forward to seeing the final product.

 

[3RAILKICK]

Your table is going to be a blast to work on. Joe stopped by and showed me some of the powder coating samples and was telling me about the color scheme. Looking forward to seeing the final product.

Donny-me too. Hope it comes out allright cosmetically-I know the rails and setup will- Some guy named Sundown doing the work.

I'm hearing that the formica near the feather strips have tap-tap dings-bummer. Is trying to replace the formica too over the top? The little that I found on AZ on the subject, sounds like a nasty project.

Talk to you in a couple of months.

ps: NON MECHANIC SHOUT OUT to Kickin' Chicken for a lot of advice on this GCII project too.