balls spit out of pocket when shot down rail

city billiards said:
Goldcrown is not taking good hard shots down the rail, the angle seems to wide. Can I angle the facing to correct this problem
Click to expand...
We need more info about the table. What kind, how old, was it recently worked on? Pic's of the pockets would be helpful. Usually when this happens, the facings just need to be replaced. Post some pic's and I'm sure Donnie or RKC could help you figure it out.
 
I took some pictures but not sure how to upload. asking for URL.
I purchased the table used and refelted it myself. The facing's were attached fine. Can you modify the facings to change the angle. Make it a little sharper. the facing would need to wedged in the thickness direction.
 
Big C said:
We need more info about the table. What kind, how old, was it recently worked on? Pic's of the pockets would be helpful. Usually when this happens, the facings just need to be replaced. Post some pic's and I'm sure Donnie or RKC could help you figure it out.
Click to expand...

has the rail cloth been pulled so hard the angle in the pocket has been changed? The angles are definitely the problem. I've never seen them corrected by making a facing shaped like a wedge. I like to correct this problem by adding a subrail extension and making the angle changes to the subrail extension, this way the rails can be changed back to stock brunswick specs. There's two angles I would change: mitre angle and down angle. I'm not goingto post the specs I like to use, but if you do some research I've seen them posted.
 
would you give me specs in confidentail email?

So you are saying add rail rubber to the end of the rail?. do I need to remove some of the original rubber?
 
You must log in or register to reply here.
Back
Top