Beautiful Tascarella

[Devilish48]

Here is a new Tascarella. This cue has just about everything you can add
except inlays. I'm going to sell this for exactly what Pete would charge for
it today. $2500 for a base cue, $500 for the ivory over steel joint, $350 for
the Hoppe ring, $300 for the full splice, and $300 for the lizard wrap, for a total
of SOLD without the 3-4 year wait. As an added bonus that is usually worth
$500 itself, the cue is hand signed by Pete Sr. Paypal as a gift, or add 4%.

The specs on the cue are as follows:

Butt - 15 oz - Bumperless Ivory Hoppe Ring
Shaft 1 - 4.3 oz - 13mm+ - Ivory Ferrule
Shaft 2 - 4.5 oz - 13mm+ - Ivory Ferrule
Joint - Piloted 5/16-14 Ivory over Stainless Steel

Everything is straight - The cue was delivered directly to me from their shop.

 

[Devilish48]

A copy of the FedEx Label, showing that the cue was shipped directly to me from Tascarella's shop.

 

[RADAR]

Nice cue there! Should not last long!

 

[Rico]

?

Can someone tell me the reason for the steel insert in the ivoryjoint ? It appears to only go down a little ways.

 

[Big-Tattoo]

nice Cue Sir, i really like it, 4,3 and 4,5 oz Shafts. I think they will deflect alot (hope I'm wrong),
Ralf

 

[Rico]

joint

thanks for pm. i wondered why because it appears to not be sleeved all the way down the joint.

 

[Devilish48]

The sleeve goes all the way to the wood inside of the joint. The ivory extends a good bit further down on the outside as it has to be sleeved over the wood tenon.

Chris