Hello. I have for sale an older Bill Schick cue. It has " The Machine" engraved on one side and a new Schick logo on the other as the old logo was missing. I sent the cue to Bill to have him re engrave his logo and while it was there I had him make a new shaft as well. The butt was out just a bit, so he straightened it back out, thus making the points more uneven. Has a new wrap. For some reason he made the new shaft at 12.8mm instead of 13mm. I inquired with him about this, but as of yet he has not responded about it.. Specs are as follows:
Butt: 28 1/4" long--15.55 oz--new wrap-- points are uneven-- re straightened by Schick
Original shaft: 28 1/8" long--3.55 oz-- 12.55 mm at tip-- not straight- thinner joint ring
New shaft: 29" long-- 3.75 oz-- 12.75-12.8 mm at tip-- wider joint ring
Butt: 28 1/4" long--15.55 oz--new wrap-- points are uneven-- re straightened by Schick
Original shaft: 28 1/8" long--3.55 oz-- 12.55 mm at tip-- not straight- thinner joint ring
New shaft: 29" long-- 3.75 oz-- 12.75-12.8 mm at tip-- wider joint ring
Last edited:
