bought a CF shaft from alibaba...

C

coderman1

New member
Calm down, it was just to try it out. It hits great and plays fine. It is a uniloc joint but the only issue is it does not fit my BK Rush, but it fits an old J. Peschaur?

Anyone know how that could be? And also how I can fix it? (maybe an extension might work?)

TIA
 
Are you sure the Pechaur is uniloq? I thought they use a quick release variant of 5/16-14. Maybe they did use uniloq at some point.

It would explain why it works on one and not the other.

Sent from my Pixel 6a using Tapatalk
 
i requested peschaur to make it with a uniloc joint because i had a uniloc shaft at the time. i also found a "3x8->uniloc" conversion joint and that fits fine as well
 
Ok. I suppose someone with the correct tap could use it on the shaft, maybe loosen it some.

I know I have had some radial shafts not fit a cheap butt. Similar problem.

Sent from my Pixel 6a using Tapatalk
 
the issue is this shaft just spins on the BK Rush butt. like the BK Rush is too small or the threads arent catching for some other reason...like they are too deep into the joint or something
 
You must log in or register to reply here.
Back
Top