sudocrushms
Well-known member
Disclaimer: I am *not* Dr. Dave.
New table, so gotta figure out the breaks.
My usual starting points:
10-ball: about half a diamond left of center, thick on the 1, half tip high, maybe 60% power.
9-ball: few inches off the left rail, thick on the 1, stun, 70% power.
Tweak from there depending on what the rack does. I had to make opposite adjustments from what i usually do (add power instead of reduce power), so it took a bit longer to figure out. Power and angle to get balls to the pockets, then draw/follow on the cb to fine tune and control the cb. You can make multiple angles work on most tables, but i like to keep the variables minimal.
New table, so gotta figure out the breaks.
My usual starting points:
10-ball: about half a diamond left of center, thick on the 1, half tip high, maybe 60% power.
9-ball: few inches off the left rail, thick on the 1, stun, 70% power.
Tweak from there depending on what the rack does. I had to make opposite adjustments from what i usually do (add power instead of reduce power), so it took a bit longer to figure out. Power and angle to get balls to the pockets, then draw/follow on the cb to fine tune and control the cb. You can make multiple angles work on most tables, but i like to keep the variables minimal.