carguy, you're not the only one dissatisfied with Brianna. I bought some lathe pins from him a few years back. they were long and had female threads on one end and male threads on the other. the price was about $150.00. I never received the pin for an Accu-Lock joint. after several emails to him, he finally sent me a negative response; telling me he had already sent it to me in the original order. so, I finally gave up on it.
about six months later, I changed to a smaller, more accurate chuck and they wouldn't go through the back of the chuck and I had to cut them in two because of the lenght to use them. SURPRISE ! , they wouldn't screw together straight ! they were tapped from each end and the hole did not line up in the middle where the threads met. most of them were off by 1/8". I had to pay dearly for somebody to true them up and make them useable. no wonder I was having nightmares trying to get the butt line up with rhe shaft when I did repairs !!!!!
of course, I had no recourse since I had modified them. took my loss (not suggesting that you do the same) and put them on my list to never buy from again. d
about six months later, I changed to a smaller, more accurate chuck and they wouldn't go through the back of the chuck and I had to cut them in two because of the lenght to use them. SURPRISE ! , they wouldn't screw together straight ! they were tapped from each end and the hole did not line up in the middle where the threads met. most of them were off by 1/8". I had to pay dearly for somebody to true them up and make them useable. no wonder I was having nightmares trying to get the butt line up with rhe shaft when I did repairs !!!!!
of course, I had no recourse since I had modified them. took my loss (not suggesting that you do the same) and put them on my list to never buy from again. d
