The guys down at the lodge asked me get everything together to refelt their Centennial table. I'm pretty sure I have a good detailed list. If I remember right, it uses K55 rubber (?), but I don't know what size the featherstrips are. I'm not even sure the tech will have to replace them but I was going to order a set anyway since they don't seem to cost too much anyway. Can anyone tell me what size they are?
Just trying to do my part as a member of the lodge. I'll let their tech do the refelt and rail job while I refinish the woodwork and do what looks like a lot of polishing. I'll take some before and after pics and post them after it's all said and done. Only thing that bothers me is that the rails have some pretty deep scratches and dents in them and I know they can't all be taken out without some extreme sanding and I don't want to take too much of the wood off the rail.
Here's the list:
Rail Rubber K55
Facings
Featherstrips
Cloth
I figure the tech should have everything else correct?
Just trying to do my part as a member of the lodge. I'll let their tech do the refelt and rail job while I refinish the woodwork and do what looks like a lot of polishing. I'll take some before and after pics and post them after it's all said and done. Only thing that bothers me is that the rails have some pretty deep scratches and dents in them and I know they can't all be taken out without some extreme sanding and I don't want to take too much of the wood off the rail.
Here's the list:
Rail Rubber K55
Facings
Featherstrips
Cloth
I figure the tech should have everything else correct?
