Brunswick label font?

ideologist

I don't never exaggerate
Silver Member
Does anyone have any ideas on a modern typeface that matches up with this font:

bbc_carom.jpg


and the Master Stroke label here:

attachment.php


I have this typeface in mind: http://www.fontspace.com/tup-wanders/forque

Anyone have any better options for matching it up? Even the K has similar features.

Any help would be appreciated!
 
Something to check out

Hey Orbis ;)

Not sure if you'll find exactly what your looking for, but one of my resources when doing graphics and in need of a unique font is Dafont.com among a few others.

I only spent a couple minutes looking, didn't find exactly what you were looking for You may be able to use a combination of fonts to get as close as possible. For example, I found several fonts with the same style "B" but the rest of the text did not match, however I found a couple that looked similar to the "unswick" portion. So if you hunt around you may be able to use a mixture of fonts to achieve your desired results. I highly doubt you'll get anything perfectly matched by going this route.

Here are a couple of quick examples, I'm sure they are not what your looking for though. Spend some time browsing the site and you just may come up with a solution. Hope you find what you're looking for;

Example #1
Example #2

Keep in mind, I only spent a couple minutes at most, and there are hours worth of searching potential on that site and others. Wish I could be of more assistance.

Dopc.

Edit: My apologies, I just assumed you were looking for the "Brunswick" portion and not the rest of the text. In the future, I need to read posts more carefully before responding.
At any rate, you should be able to run across something close at dafont.com or the many font sites on the web. Dafont also has a forum, you may be able to post that picture on and some kind sole may create it for you, but no guarantees.
 
Last edited:
That's where I got the picture, ha. I need to laser engrave a piece to match the label - CAROM KING
 
Why not enlarge it then have it vectorized?

I can have that done in our sign shop but I just started my vacation and wont be back at work for awhile.

Its been sometime since I have done image tracing of any kind but I still have the equipment.
 
Back
Top