Builder ID needed

[Dave38]

I just did a repair for a buddy and his cue was really nice. I don't have pics as I gave it back to the guy already, but he called today to ask me if I could find out about it. It was a fullsplice with no wrap, looked like mahogany in the front with E.I. rosewood for the butt. There were initials on the butt cap, in gold lettering, 'K' over a 'C'. Black butt cap. The joint pin was a brass 3/8x11 by the looks of it. The ring work was maple rings with maple slots with black rings on the outsides. It is a very well made cue.
Any ideas are welcome. I will try to get a picture when I see him this week.
Thanks,
Dave

 

[Lazerrus]

Not sure about K OVER C but a K next to a C would be KC Custom cues. I believe they are imports and are all over ebay. Like this one pictured below. Hope this helps.

 

[Dave38]

Thanks for the reply and to the ones that pm'ed me. One other description is that there was a phenolic insert in the shaft, if that helps. I should be seeing him tomorrow nite, so I'll try to snap a couple of pics.
Dave

 

[Dave38]

I stand corrected, it was KC not K over a C. I need new glasses....
Here are a couple pics, crappy cell phone pics I must say. I am impressed that it has a phenolic insert in the shaft. Maybe a after market addition. It shoots and feels very well for an import.
Thanks for the help everyone.
DAve

 

[Dosed]

kc customs. They are not custom. Mass produced. look on ebay for them.

 

[OTB]

KC cheap import, not bad quality, i sell them for about $80-125 in my store.