I have for sale a jump/break cue with 3 shafts; I have no idea who made it.
Curly maple front with cocobolo handle, 3/8x10 joint pin, modified 5/16x18 quick release jump joint. Silver rings at A,B,C, and E. Butt is 15.0 oz, 29" in length. Couple of dings in the finish, would rate it 8/10.
Shaft 1 is the only shaft with matching ringwork (guessing it is original), has some type of lighter colored layered tip, has a 12.8mm tip diameter, is 30" in length and weighs 3.8 oz. Straight when rolled together with butt.
Shaft 2 is a non-layered harder tip, 12.6mm tip diameter, 28.5" in length, weighs 3.6 oz. Would consider this more of a playing shaft. Slight roll when rolled together butt, about a credit card's width.
Shaft 3 is a purpleheart shaft, non-layered hard tip, 13.5mm tip diameter, 30" in length, weighs 4.7 oz. Some tooling marks on ferrule. Joint diameter does not match, is about 0.030" or so smaller than butt. A little more roll than Shaft 2, tip does not leave the table though. Jumps/breaks awesome if you can ignore the mismatched joint diameters.
$150 shipped CONUS via PayPal. Hits solid, plays good and jumps/breaks as good as anything else. Feel free to ask any questions and I'll answer them to the extent I can.
Curly maple front with cocobolo handle, 3/8x10 joint pin, modified 5/16x18 quick release jump joint. Silver rings at A,B,C, and E. Butt is 15.0 oz, 29" in length. Couple of dings in the finish, would rate it 8/10.
Shaft 1 is the only shaft with matching ringwork (guessing it is original), has some type of lighter colored layered tip, has a 12.8mm tip diameter, is 30" in length and weighs 3.8 oz. Straight when rolled together with butt.
Shaft 2 is a non-layered harder tip, 12.6mm tip diameter, 28.5" in length, weighs 3.6 oz. Would consider this more of a playing shaft. Slight roll when rolled together butt, about a credit card's width.
Shaft 3 is a purpleheart shaft, non-layered hard tip, 13.5mm tip diameter, 30" in length, weighs 4.7 oz. Some tooling marks on ferrule. Joint diameter does not match, is about 0.030" or so smaller than butt. A little more roll than Shaft 2, tip does not leave the table though. Jumps/breaks awesome if you can ignore the mismatched joint diameters.
$150 shipped CONUS via PayPal. Hits solid, plays good and jumps/breaks as good as anything else. Feel free to ask any questions and I'll answer them to the extent I can.