showtimenga
Registered
Hello all... sorry if this is the wrong spot to post this... but I'm looking for a cue lathe repair / and build a little for around 2k if anyone has any lead plz text 912 592 9514 thanks agine..
Cue lathe
- Thread starter showtimenga
- Start date
Atlas
Looks like a10 or12 inch. I started out on one just like it. Looks like It has a taper bar already. The only problem with those is the 11/16" i.d. spindle bore. You will need to make a bearing and collets to do joint work (facing,drilling and taping for the joint pin etc) on the butt. Other than that they work well.
Would make a great second operation, wrapping, chassis component building machine. Does full length turning very nicely at a carriage speed of 29"/ 6 minute's .
Looks like a10 or12 inch. I started out on one just like it. Looks like It has a taper bar already. The only problem with those is the 11/16" i.d. spindle bore. You will need to make a bearing and collets to do joint work (facing,drilling and taping for the joint pin etc) on the butt. Other than that they work well.
Would make a great second operation, wrapping, chassis component building machine. Does full length turning very nicely at a carriage speed of 29"/ 6 minute's .
Gary Bluhm
Registered
There is a fella selling one on AZBilliards. Don't know his selling price.
I just bought a used mint condition cuesmith deluxe for under $800. Came with everything for repairs and beginner building. I'd recommend it for starters or accurate repairs. Good luck.
Sent from my Nexus 6P using Tapatalk