Cue Spinner

W

Walter

New member
This is a picture of a "Cue Spinner" I have for sale on ebay. It is like a poor man's lathe and is good for retipping, shaft smoothing and possibly non-threaded ferrule replacement (although I haven't tried that).

P1010028.JPG

It is homemade and looks it. Some of you may want to go to ebay, check out the other photos, and make your own similar spinner.

Enjoy,
Walter
 
Suggestion: If you want anyone to look at anything on the internet provide a link for them to the item. You will discourage at least half of the population if you didn't make it easy for them when you could have.
 
You need your own 3/8" drill to spin it. My drill only locks at full speed so I use a velcro strap around the trigger to set the speed where I want it. You could mount your own motor with a foot speed control, but a drill works fine for me.
 
sell

Walter,

Why not post a buy it direct price for members here on the board. bet you could sell several without auction fees

Joe
 
You must log in or register to reply here.
Back
Top