Cuemakers, can you build this extension?

[Catalin]

I'm looking for an extension that can work with a standard cue and I came across this design. I believe that the protruding wooden part plugs the hole where the rubber bumper goes, and the screw screws into the weight bolt thread. How easy or complicated is something like that to build, and can one of you gentlemen build it and send it to me before December 31st?

Thanks,
Julian

 

[JoeyInCali]

Show the bottom of YOUR CUE.
Take the rubber bumper out.
It might have a weight bolt.

That extension only works with that kind of rubber bumper .
It has .590" by 1/2 long stem.https://prathercue.com/products/rubber-bumper-r9?variant=39145318663

 

[Catalin]

Show the bottom of YOUR CUE.
Take the rubber bumper out.
It might have a weight bolt.

That extension only works with that kind of rubber bumper .
It has .590" by 1/2 long stem.https://prathercue.com/products/rubber-bumper-r9?variant=39145318663

Why would the extension only work with that bumper? If it's made specifically for my cue it would fit the specs of my cue, whatever they are.

 

[JoeyInCali]

How about that picture of your cue?

 

[Catalin]

How about that picture of your cue?

Hi Joey, the cue is not ready yet but I know the specs. The butt is 1.24, it will have a rubber bumper and a ½ or 5/8 by 18 weight drill. I know that the diameter of the bumper hole is also important and I can find that out. I was hoping to have the exension made at the same time.

 

[JoeyInCali]

Hi Joey, the cue is not ready yet but I know the specs. The butt is 1.24, it will have a rubber bumper and a ½ or 5/8 by 18 weight drill. I know that the diameter of the bumper hole is also important and I can find that out. I was hoping to have the exension made at the same time.

3/8 16 set screw as weight bolt would make it simpler.
Why don't you ask him to make the extension?