Cuetec pin

[j2pac]

Would anyone happen to know if Cuetec has always used a 14tpi thread? I would also like to know if their joint diameter has changed any over the years? My thanks in advance for any help/information.

 

[Michael Webb]

Would anyone happen to know if Cuetec has always used a 14tpi thread? I would also like to know if their joint diameter has changed any over the years? My thanks in advance for any help/information.

Same joint screw.
Joints are approximately
.790 and .838
All the new one's with a Cynergy shaft are .838

 

[j2pac]

Same joint screw.
Joints are approximately
.790 and .838
All the new one's with a Cynergy shaft are .838

Thank you Sir.

 

[Kim Bye]

I just did a few shafts for older Cuetec cues and I used my standard minor and that seemed to work fine. These cues must have been from the early 2000's