Cutting and jointing a valley supreme

demon627 said:
Just looking at having this done and was looking for a price range
Click to expand...

The quickest and easy way is just to cut it and put in a 3/8 10 or radial pin. It is easier then doing a ferrule. I do it for friends for nothing but you can expect to pay about $50.00. To do it right you have to sand the joint even a little because you are removing a small amount of material from a tapered piece and give it a quick spray of finish. The finish is not completely necessary though, you can hit it with a little wax.
 
Just measure the diameter twice 90* from each other. I added a joint to an Action house cue and discovered the hard way the it wasn't even round; kinda egg shaped.
 
You must log in or register to reply here.
Back
Top