FlashPoint77
Registered
I live in Texas. I will take pictures the next time they come out ..and you will then see the level ..ahah.
Last edited:
Did i buy a p.o.s. Table>?
- Thread starter FlashPoint77
- Start date
I have worked on a lot of Brunswicks, when i saw the vid of your roll, i had a thought. It was actually the first thing i looked at when leveling a brunswick home table.
go look under your table at one end panel, look up in the corners, above the corner cap, right under the corner pocket plate. See if the end panel is flush with side panel on both sides and ends. by the way the ball rolled the first couple of times, maybe the end panel lower then the side panel. when the slate screws were tightened down on the end slate it got "cupped" slightly side to side.
go look under your table at one end panel, look up in the corners, above the corner cap, right under the corner pocket plate. See if the end panel is flush with side panel on both sides and ends. by the way the ball rolled the first couple of times, maybe the end panel lower then the side panel. when the slate screws were tightened down on the end slate it got "cupped" slightly side to side.