Dust control on lathe..
- Thread starter Newton
- Start date
I got this setup from Tom Hassos "datum cue"
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Looks good. Just a thought here, but what If You made another that's identical to go on the other side, and then plumb up a manifold to connect the intakes together into one line? You may not be able to see the cutter, but I wonder If It would increase the amount of pickup? With an adjustment like you have on that, It seems like you could bring them closer together as the work piece gets smaller.
Last edited:
I got this setup from Tom Hassos "datum cue"
Sent from my iPhone using Tapatalk
Thats one nice setup. I guess there is not that much dust from that one
I think the only solution which would make this 100% would be something similar as yours or as you mention another brush on the other side.
But it might be a little hard to operate. Long time since I used the CNC for this purpose but I'll do a revisit on it during December;-)
K
Thats one nice setup. I guess there is not that much dust from that one
No doubt. I know that Tom still has a few of these available.
All of his work is tip notch. I absolutely this setup.
Would not fit my quick change tool post - it looks like the wedge design. I have which the manufacturer called "German style" http://forums.azbilliards.com/showthread.php?t=119423&page=2
Might make something similar in thick plexi or something for my CNC.
Cool setup though.
K
Very cool ! You have given me some good ideas.