F/S AC gearmotor 48 rpm

Dave38

Dave38

theemperorhasnoclotheson
Silver Member
I bought 2 of these motors but actually only can use one so I'm offering the other one here. It is AC, motor with gearbox, reversable if you use a simple DPST switch. The wires are common, foward, reverse. A wiring diagram/spec sheet is included as well as the starting capacitor. These babies actually have a lot of torque for their size. The gear on the shaft is permanent, but there is about 1/2" of space to put a pulley of your design on it. I am using mine for my finish booth drive motor. Price is SOLD shipped. It weighs in at 5 lbs so it will be sent medium flat-rate box to the 50 states(thanks TW for the info):wink: No international, sorry.
If you buy it and don't like it, or have any problems hooking it up, call or contact me within a few days for receiving it, and I'll help over the phone, or I'll take it back.
Thanks,
Dave

stuff 001.jpg

stuff 003.jpg
 
Last edited:
If the motor is continuous duty it would be a great deal for someone wanting to use it to slow their lathe down for applying the Cue Cote finish.
 
cueman said:
If the motor is continuous duty it would be a great deal for someone wanting to use it to slow their lathe down for applying the Cue Cote finish.
Click to expand...

I have run mine for about an hour so far and it didn't even get warm. The spec sheet has all ratings listed as 30 minute minimum tests. All the info points to continous duty. It runs super quiet too. Brand new these were pretty expensive motors and gearheads.
Here is the pdf spec sheet for the motor.:http://www.orientalmotor.com/products/pdfs/2000-2001/4RK25GN-AUL.pdf

It is the 4RK25GN-AUL motor. This gearhead is one half of the 4LB45N-5 linear head. The other half has been removed to allow access to the shaft to attach a pully to it.
Any questions, please ask me.
Thanks,
Dave
 
You must log in or register to reply here.
Back
Top