Feeler: Any interest in 3/8x10 & 5/16x14 Grade 5 titanium joint pins

[Tikkitavi]

I am having some made for a fellow AZer. He suggested that I see if anyone else has interest in purchasing some. The 3/8x10 will be fully threaded and 3.5 inches long (minimum 3.25 inches of thread). The 5/16x14 will be fully threaded and 3.25 long (minimum 3.0 inches of thread). As the Title reads they will be made of Grade 5 Titanium and not Grade 2. Same weight but Grade 5 is much stronger and will polish close to a mirror finish.

The prices will be as follow:
1 to 4 pcs. $15.00 each
5 to 9 pcs. $14.25 each
10 to 19 pcs $13.50 each
20 and over $12.50 each
**Prices do not include shipping**

All the way from start to the finish these items can and will be labeled Made in the USA.

They will be complete and ready for the Super Billiard Expo. Pick them up at SBE and you don't have any shipping cost. So if you have interest please drop me a PM. I am only having a limited run made.

Thank you,
Rik Graham

 

[dave sutton]

Are the center drilled type or the acme style

 

[merylane]

I am having some made for a fellow AZer. He suggested that I see if anyone else has interest in purchasing some. The 3/8x10 will be fully threaded and 3.5 inches long (minimum 3.25 inches of thread). The 5/16x14 will be fully threaded and 3.25 long (minimum 3.0 inches of thread). As the Title reads they will be made of Grade 5 Titanium and not Grade 2. Same weight but Grade 5 is much stronger and will polish close to a mirror finish.

The prices will be as follow:
1 to 4 pcs. $15.00 each
5 to 9 pcs. $14.25 each
10 to 19 pcs $13.50 each
20 and over $12.50 each
**Prices do not include shipping**

All the way from start to the finish these items can and will be labeled Made in the USA.

They will be complete and ready for the Super Billiard Expo. Pick them up at SBE and you don't have any shipping cost. So if you have interest please drop me a PM. I am only having a limited run made.

Thank you,
Rik Graham

those sound great ..... especialy since the usual guy isnt comming through.

if these are good quality and full deameter ( .375 and .312 ) sign me up

for a couple hundred.

 

[Tikkitavi]

Are the center drilled type or the acme style

They will be your standard 3/8 x 10 thread and 5/16 x 14 thread (not ACME) except they will be full sized .375 & .3125. I am sure that the machinist is using center point for cutting the threads. The company that is machining these specializes solely in titanium. Specs were given to me by a top cue maker. I know because the screws will be fully threaded will limit the potential purchasers. I am not having them made for just any "Joe Cuemaker"(not used in disrepect). They are being made with the highest standards to meet the criteria of the Highest level cue makers. Maybe I will get lucky have them stamped, Elf tested, Elfin' Magically approved.

 

[Tikkitavi]

They arrived today. Sorry about the dust, I did not blow them off before I took the pictures. Fully threaded and to specs.