Ferrule Replacement — Cuetec Synergy

[Goosekeeper]

Any recommendations for someone who can do a good job replacing a ferrule on a Synergy shaft?

Came with white, switched to g10, want to go back to white. I’m in Los Angeles, btw. Would appreciate any leads. Thanks!

 

[crocdoc]

Tiger does a great job but not sure if he has white
He has the color he uses though-have one that he done
Plays great

 

[Goosekeeper]

Tiger does a great job but not sure if he has white
He has the color he uses though-have one that he done
Plays great

I get a lot of work done at Tiger. Good friends with them. The white they have isn’t the kind it came with. Looking to do a “factory reset”.

 

[j2pac]

I get a lot of work done at Tiger. Good friends with them. The white they have isn’t the kind it came with. Looking to do a “factory reset”.

Why?
Since you have already had the ferrule changed, I would recommend replacing the G10 with Tomahawk ferrule material. A few folks on the forum have used the material as a replacement. They all seem to be more than satisfied.
Best regards.
j2

 

[Goosekeeper]

Why?
Since you have already had the ferrule changed, I would recommend replacing the G10 with Tomahawk ferrule material. A few folks on the forum have used the material as a replacement. They all seem to be more than satisfied.
Best regards.
j2

Why? I guess I don’t love the color of the G10 for sighting. Prefer the white color. G10 also hits a little too stiff for me. I’ll look into tomahawk. Appreciate the tip!

 

[Terry Aeschliman]

I could do it in Tomahawk for $40 but you would have shipping to and from Indiana