Finally (My new U-Channel Extrusion)

[customcuelathe]

Here it is, I just got back from LA and at my door step was my approval sample for my newly designed U-channel, with 50% thicker walls, still 100% compatible with taig parts and all cue lathes that are based on taigs parts, deep dovetail cuts on the sided of easy mount for autofeed attachment and taper bar attachment on the opposite side. 3" total hight for easier hand wheel movement, and lots more.
And there is a lot more new designs comming soon, when everything is said and done, my cue lathes will be one of a kind.
Regards

 

[poolcuemaster]

How much for a 7 foot piece and you can pm me.--Leonard

 

[customcuelathe]

How much for a 7 foot piece and you can pm me.--Leonard

$20/ft
Leonard
sorry, but I ordered all mine in 4 ft section to allow for a gap for the auto feed belt, lead screw bearing and bracket, you can get 2x 4fts at long as your dovetail is one piece it shouldn't matter.
I just got a small shipment to try it out, If I get enough request for 7ft section, I will get some more, it only takes couple of weeks now that the die is done.
Regards