http://forums.azbilliards.com/showth...ighlight=roger
Goncalo Alves into Gaboon Ebony SP
2 original predator 314, partials matched to cue by Bryan.
58.5", 29.5 butt/29 shafts
19.3 oz one shaft, 19.4 second shaft. No calipers but both shafts feel full 12.75 at least.
Ivorene 4 joint
Titanium 3/8-10 flat-bottomed pin
Ivorene/bloodwood rings
Delrin buttcap
I ordered this cue 3 years ago and it's been sitting in my case after one brief session. Each shaft had approx. an hour or so of play on them. I haven't been near a pool table in over a year lol...
I neglected to inform Bryan that I usually play with cues that have thicker buttsleeves than usual; by the time I told him it was too late. The cue plays very, very solid, but I can't get used to the slimmer buttsleeve (where I hold the cue) on most "standard" butt tapers these days.
$450 + shipping. Willing to break up the shafts/butt etc. No trades (unless you have a Shimano Stella or Daiwa Saltiga
)
thanks,
roger
Goncalo Alves into Gaboon Ebony SP
2 original predator 314, partials matched to cue by Bryan.
58.5", 29.5 butt/29 shafts
19.3 oz one shaft, 19.4 second shaft. No calipers but both shafts feel full 12.75 at least.
Ivorene 4 joint
Titanium 3/8-10 flat-bottomed pin
Ivorene/bloodwood rings
Delrin buttcap
I ordered this cue 3 years ago and it's been sitting in my case after one brief session. Each shaft had approx. an hour or so of play on them. I haven't been near a pool table in over a year lol...
I neglected to inform Bryan that I usually play with cues that have thicker buttsleeves than usual; by the time I told him it was too late. The cue plays very, very solid, but I can't get used to the slimmer buttsleeve (where I hold the cue) on most "standard" butt tapers these days.
$450 + shipping. Willing to break up the shafts/butt etc. No trades (unless you have a Shimano Stella or Daiwa Saltiga
)thanks,
roger
Last edited:
