Fixing a bad install

poolshooter850

AzB Silver Member
Silver Member
Should've known better when the installer tried using a water putty mix, that he had to mixed and then place on the table that I was going to have issues. After the mixed dried it shrank into the bed screw holes and the seams between the slate. I had never seen anyone use anything other than wax on the seams but I didn't have the time to do this myself. Can I go back and just scrape off the residue and use wax to make sure I don't have holes in the middle of the slate and wax over where the slate meet? Looks like I'm doing it myself anyway.


Sent from my iPhone using Tapatalk
 

kid

billiard mechanic
Silver Member
Water putty is very easy to clean up : little scraping and a wet rag after. You'll never see it was used in the first place


Envoyé de mon iPhone en utilisant AzBilliards Forums
 
Top