I decided to go in a different direction and need to sell the Techno Isel before I proceed. When I purchased the Techno the computer was old and did not work. I replaced the computer and installed and arm to hold the monitor and keyboard. I also had two ground ball screws made up for the machine. I never installed them because it would have taken some modification to get it done, cost me $1,400. The front and rear support plate was 1/4" thick, replaced it with 1/2" aluminum. Latest software from Techno is installed, but I have not cut anything with it yet because I am not familiar with the software. First $6,000 takes it, only local pick up no shipping.
Sent from my iPad using Tapatalk HD
Sent from my iPad using Tapatalk HD
