FS 2 Maintenance pins (arbors)

lights_out

lights_out

AzB Silver Member
Silver Member
I bought these two maintenance pins as part of a set and have no need for them. They are 5/16-18 & 3/8-10. Here is part of the description for the auction, with permission from the seller champ***:

They are made out of Stainless steel with a 3/8 shank.

These pins are 100% concentric. Precision machined to run 100% true so your shaft won't wobble while turning.

These pins are precision machined on a cnc lathe and everything is done in one set up so there is no run out of any kind.

I am selling them for $20 each shipped. I prefer paypal but will accept other payments as well. PM or e-mail stevelee21@comcast.net.

Also, I don't have any cues with either of these joint pins so you'll have to help me out as I won't know which one is which. If you're interested, please let me know the one on the left or right.:confused:

Thanks
 

Attachments

  • arbors.jpg
    arbors.jpg
    43.9 KB · Views: 129
Last edited:
mooseman said:
Since you don't show a 5/16x14 where did you originally buy from?
Click to expand...


The one on the far right is 5/16x14, and I'm keeping that one. I got the set off of ebay.
 
Last edited:
lights_out said:
The one on the far right is 5/16x14, and I'm keeping that one. I got the set off of ebay.
Click to expand...

Partner, I bought the same set off ebay. Now what you said above is not true for the ones I received. The ones I received were not properly Machined and caused a major wobble between the chuck and my live center.

Good Luck with your sale!!!!
 
manwon said:
Partner, I bought the same set off ebay. Now what you said above is not true for the ones I received. The ones I received were not properly Machined and caused a major wobble between the chuck and my live center.

Good Luck with your sale!!!!
Click to expand...


I just chucked the 5/16-14 & uni-lock arbors into my drill with shafts attached and they are DEAD STRAIGHT. I also chucked the 5/16-18 & 3/8-10 into my drill without shafts, as I said I don't have shafts with those pins, and by eyeballing them, they look straight as well. Of course, if they are sold and the buyer tells me otherwise, I'll PROMPTLY issue a refund. As far as I can tell by looking at them, they are very well made. Sorry to hear about your bad set.
 
You must log in or register to reply here.
Back
Top