i have this full splice titlist conversion by an unknown maker but judging by the brass joint and pin i'm guessing it's pretty old. cue was recently refinished, rewrapped and the shaft reconditioned, by Richard Hsu a cuemaker out of brooklyn and has only been test hit since.
weight of the butt's about 16 oz and the shaft's about 3 1/2 oz give or take a little here or there. the balance is good so it doesn't feel all that heavy when shooting.
one shaft and, at the tip, it's 12.5mm. the taper's a little fat so it doesn't feel that thin when shooting. there is a slight roll but the collar and the tip stays on the table. not sure if it's the taper or if it was the table but given the age of the cue the shaft's pretty damn straight.
looking for $595 shipped and insured in the 48 states.
open to trades as well.
paypal accepted from verified members.
weight of the butt's about 16 oz and the shaft's about 3 1/2 oz give or take a little here or there. the balance is good so it doesn't feel all that heavy when shooting.
one shaft and, at the tip, it's 12.5mm. the taper's a little fat so it doesn't feel that thin when shooting. there is a slight roll but the collar and the tip stays on the table. not sure if it's the taper or if it was the table but given the age of the cue the shaft's pretty damn straight.
looking for $595 shipped and insured in the 48 states.
open to trades as well.
paypal accepted from verified members.
Last edited:
