Sold FS Huebler cue

Sold Item
dquarasr

dquarasr

Registered
I believe this has a shaft with a pro taper as it narrows about 12” from the tip.

I had the butt rewrapped by the professional cue service man at my local hall (Lt Dan).

Condition is average; it's not perfect, but it's not bad. Normal wear and tear. One very small dent around 9" from the ferrule.

I purchased this cue used. As such I am not 100% sure which model it is. But based on what I was able to find online, I believe it to be an AS-1, of unknown vintage. You now know what know about it.

Asking $125, buyer pays shipping.

UPDATED 6/10/21 ~7:45PM EDT:

PLEASE excuse my naivete regarding specs. I am not well versed in equipment.

I measured the cue with a kitchen scale and a vernier caliper. Here are specs:

Shaft: 4.1 oz
Butt: 16.2 oz
Tip: 13mm

The butt was wrapped with what I think is linen thread (?). Closeup photo added. Also, as I am unfamiliar with the names of joint types, I added ac closeup photo of the joint. And for good measure, I also added a closeup of the butt end under the rubber plug where I assume weight can be adjusted.
 

Attachments

  • IMG_3003 (1).jpg
    IMG_3003 (1).jpg
    221 KB · Views: 209
  • IMG_3004 (1).jpg
    IMG_3004 (1).jpg
    256.1 KB · Views: 198
  • IMG_3008.jpg
    IMG_3008.jpg
    261.8 KB · Views: 168
  • IMG_3009.jpg
    IMG_3009.jpg
    200.6 KB · Views: 160
  • IMG_3015.jpg
    IMG_3015.jpg
    94.4 KB · Views: 177
Last edited:
can you give some specs on the cue, butt wieght shaft weight shaft diameter at the tip type of pin etc
what type of wrap is that, hard to tell from the pics
 
Per forum rules please communicate further via private messages. PM sent. Original post updated with additional info. Hope this helps.
 
Last edited:
You must log in or register to reply here.
Back
Top