Cupboard clean-out cue #3:
This is an original Stinger jump/break cue made by Jerry Powers at Jerico Cues before the design was sold to McDermott. I believe the exact model was the SG1.
It is a full splice cue with the original hard leather tip and ferrule. (No phenolic here so you can use this anywhere.) There is ding in the butt through the finish (See the last picture) and several other small dings in the shaft and butt from normal use. None of this effects how it plays or feels.
The shaft has a very minor taper roll (The tip does not leave the cloth when rolled) and butt is straight and solid.
Specs:
Butt: 14.2oz, 28.5" + 0.5" for the rubber bumper
Break shaft: 4.1oz, 30", 13.3mm
The joint pins are some kind of modified quick-release, not sure the exact specification, but black plastic joint protectors are included.
Pictures:
SOLD PENDING PAYMENT
This is an original Stinger jump/break cue made by Jerry Powers at Jerico Cues before the design was sold to McDermott. I believe the exact model was the SG1.
It is a full splice cue with the original hard leather tip and ferrule. (No phenolic here so you can use this anywhere.) There is ding in the butt through the finish (See the last picture) and several other small dings in the shaft and butt from normal use. None of this effects how it plays or feels.
The shaft has a very minor taper roll (The tip does not leave the cloth when rolled) and butt is straight and solid.
Specs:
Butt: 14.2oz, 28.5" + 0.5" for the rubber bumper
Break shaft: 4.1oz, 30", 13.3mm
The joint pins are some kind of modified quick-release, not sure the exact specification, but black plastic joint protectors are included.
Pictures:
SOLD PENDING PAYMENT
Last edited:
