FS: PFD Studios 4 Point Cue w/ Ivory Uni-loc Joint

Baxter

Baxter

Out To Win
Silver Member
I have for sale a beautiful 4 point 3 veneer maple into ebony cue with an ivory uni-loc joint and leather wrap. This cue was made by Paul Drexler in 2001. The butt on this cue weighs in at 16.26 ounces. The shaft is a Predator blank, 12.99mm, and weighs in at 4.05 ounces with an ivory ferrule. This cue is a little over 59", even split. The cue rolls nearly dead straight, with only the slightest taper roll that is barely noticeable. You have to look for it to find it. There is one mark in the finish on the buttsleeve (pictured), and a little bluing on the shaft. This is a great playing cue with a solid hit, and also a great looking cue. I'm pricing this cue at a steal, SOLD.
 

Attachments

  • pfd4.jpg
    pfd4.jpg
    92 KB · Views: 1,828
  • pfd3.jpg
    pfd3.jpg
    86.5 KB · Views: 1,581
  • pfd2.jpg
    pfd2.jpg
    91.7 KB · Views: 1,570
  • pfd1.jpg
    pfd1.jpg
    99.3 KB · Views: 1,519
Last edited:
Great looking cue that plays even greater for a good price. I'm surprised no one has picked this one up yet.
 
I think anybody is going to be hard pressed to find a better cue for this price.
 
Info

Baxter said:
Great looking cue that plays even greater for a good price. I'm surprised no one has picked this one up yet.
Click to expand...


I don't understand it either. This is a great deal...wish I had the cash...but I'm cue poor right now. I have about 20...need to sell at least 6 or 7.

If I have the money, this WOULD be mine. Take payments...lol.
 
jjollie said:
I don't understand it either. This is a great deal...wish I had the cash...but I'm cue poor right now. I have about 20...need to sell at least 6 or 7.

If I have the money, this WOULD be mine. Take payments...lol.
Click to expand...

Well if someone doesn't pick it up I'll save it for you lol. I've had a lot of interest, but no one has pulled the trigger yet. Not sure why.
 
You must log in or register to reply here.
Back
Top