Fs: Veneer glue up jig!!
- Thread starter leon sly
- Start date
Jig
I will take the jig.
Send paypal.
V/r
Richard
I will take the jig.
Send paypal.
V/r
Richard
anymore jigs
Hi
If that's sold would you like to make another and sell it?
thanks, Bill
Hi
If that's sold would you like to make another and sell it?
thanks, Bill
It was made by PETE TONKIN, so you will have to contact him. He is on here, and goes by his name for his username.
Dave
Aluminum cuts about the same as wood. If you are going to be using veneers then you have a 90 deg V cutter. Just get a piece of square aluminum and make your own. Piece of cake really. I cut my veneers on a taper so if I was inclined to make one of these I would make it on a taper also so that when I put my veneer stacks in they could be even with the outer edge of the jig so that the rubber bands or what ever that is used will hold them in contact but won't force the veneer stacks over any.
Dick
Dick