Wrapless Titlist conversion by Steve Therrien of Therrien Cues. The cue comes with it's original shaft with ivory ferrule from when it was a one-piece cue. This is rare as most are warped or unsalvageable. It was made to hit like a true one piece titlist.
Cue made of tightly grained straight-grain maple and highly figured reddish rosewood - looks almost like cocobolo (extrememly similar to Efren's Titlist conversion). Both ferrule and Hoppe-ring are both ivory, tan phenolic and brass rings at ivory Hoppe ring and joint, original Willie Hoppe signature and weight stamp are still fully visible. Points are even and in excellent condition. Cue has an excellent old patina, the shaft is old honey colored maple which matches the butt perfectly since it is original to the cue. The shaft has a taper roll of less than a credit card, it's barely noticeable but must be mentioned, and is not uncommon for a cue around 70-80 years old. Butt is straight. Cue is in excellent condition free of dings and dents. Price is $sold$ shipped. Not interested in trades.
Here's the specs:
Pin: 3/8x10 G10
Length: 57.5 in (Butt - 29in / Shaft - 28.5 in)
Weight: 18 oz (Butt - 14.5 oz / Shaft - 3.6 oz)
Diameters:
- At Hoppe-ring - 1.337 in
- Base of points - 1.174 in
- Top of points - 0.919 in
- At joint - 20.57mm
- Tip/base of ferrule - 12.47mm
Cue made of tightly grained straight-grain maple and highly figured reddish rosewood - looks almost like cocobolo (extrememly similar to Efren's Titlist conversion). Both ferrule and Hoppe-ring are both ivory, tan phenolic and brass rings at ivory Hoppe ring and joint, original Willie Hoppe signature and weight stamp are still fully visible. Points are even and in excellent condition. Cue has an excellent old patina, the shaft is old honey colored maple which matches the butt perfectly since it is original to the cue. The shaft has a taper roll of less than a credit card, it's barely noticeable but must be mentioned, and is not uncommon for a cue around 70-80 years old. Butt is straight. Cue is in excellent condition free of dings and dents. Price is $sold$ shipped. Not interested in trades.
Here's the specs:
Pin: 3/8x10 G10
Length: 57.5 in (Butt - 29in / Shaft - 28.5 in)
Weight: 18 oz (Butt - 14.5 oz / Shaft - 3.6 oz)
Diameters:
- At Hoppe-ring - 1.337 in
- Base of points - 1.174 in
- Top of points - 0.919 in
- At joint - 20.57mm
- Tip/base of ferrule - 12.47mm
Last edited:
here's my email