captainjko Kirk Silver Member May 3, 2017 #1 If you wanted to remove a G-10 radial pin and replace it with a stainless steel one, how would you do it? It is glued in with Devcon 5 minute epoxy... Cut off, drill, and retap?
If you wanted to remove a G-10 radial pin and replace it with a stainless steel one, how would you do it? It is glued in with Devcon 5 minute epoxy... Cut off, drill, and retap?
whammo57 Kim Walker Silver Member May 4, 2017 #3 why do you want to replace it???? it gives a crisper hit than a SS pin?? yes cut it off and drill it out...........you might get away with tapping the hole but I suspect you will need to plug it and start from scratch Kim
why do you want to replace it???? it gives a crisper hit than a SS pin?? yes cut it off and drill it out...........you might get away with tapping the hole but I suspect you will need to plug it and start from scratch Kim
