Gandy rails

[blackflagsailor]

I have read a few things on here about Gandy rails being incorrect. They seem to sit too low and cause the balls to hop. I would like to have my rails professionally modified before installing new cushions (and new cloth!). I’d like to know all your thoughts, advice, and information on this.

 

[ArizonaPete]

We have two Gandy G's in my club-house and both play very well. Haven't experienced any ball hopping no matter how hard the cue ball is struck into a cushion. It may be possible that the wrong cushions were installed on your table when it was last re-cushioned and recovered. If you could measure the height and width of the cushion and post that info, perhaps a table mechanic could let you know what the problem might be.

 

[blackflagsailor]

I’ve heard from many sources that Gandy didn’t make their rails right at the factory. You can absolutely see a sharp change in the rail where the rubber is. I will try pulling the cloth and take my own measurements. So far as I know, the rubber is the original installed rubber. It is rock hard and completely dead which is why I am putting on new cushions.

Those of you who have worked on Gandy cushions, what have you done, if any modifications were needed?