R rrich1 AzB Silver Member Silver Member Jun 27, 2011 #1 Hi, I searched but could not find it. What are the original pocket sizes for GC3's? Right now my castings are getting powdercoated so i cannot check them. I am hoping to have jzmechanix extend the rails and set up my table later in the fall. thanks.
Hi, I searched but could not find it. What are the original pocket sizes for GC3's? Right now my castings are getting powdercoated so i cannot check them. I am hoping to have jzmechanix extend the rails and set up my table later in the fall. thanks.
JZMechanix Active member Silver Member Jun 28, 2011 #2 Hard to say, but if they are original from the factory with 1/8" facings they are probably around 5" in the corners and 5 1/2" in the sides.
Hard to say, but if they are original from the factory with 1/8" facings they are probably around 5" in the corners and 5 1/2" in the sides.
