Got tips for making tenon by hand?

[Paul_#_]

I am repairing a shaft that had a slip-on ferrule. There was no tenon. I am making a tenon.

What advice do you for doing this by hand --- for cutting the shaft to make the tenon, and, especially for ensuring the ferrule placed on the tenon is flush with the shaft?

I cut the shaft first by placing blue tape around it so that the tape edge was straight --- so that where the ends of a strip of tape met were straight. I cut into the shaft at tape edge around the shaft only a few millimeters with a small hack saw. I finished with a knife to whittle down the shaft and make the tenon. Some sanding to complete.

I try to check whether the the tenon bottom that meets the shaft is flush (at right angle to shaft) with a razor blade by seeing if the flat razor blade is flat against the tenon bottom. I also try to see if the tenon is flush by noting where the ferrule rubs against the shaft. I do this by sprinkling flour on the tenon and seeing where the ferrule scrapes on the shaft. I magic markered the tenon bottom, turned the ferrule on the tenon many times, and saw where the wear marks were after turning the ferrule on it.

I think the tenon is OK using these methods but suspect much better methods are available.

__

 

[chuckpilegis]

Drill,plug and then turn down the plug to fit? I think the way you did it would make the shaft shorter

 

[Paul_#_]

Drill,plug and then turn down the plug to fit? I think the way you did it would make the shaft shorter

Yes, it would.
This work isn't really done for customers. It makes little difference to the players that use these cues (this cue happens to already be a little-used shorty --- a one-piece 52" cue). That repair would be more work than what I am doing. Nonetheless, to keep cue length the same (and all that comes with it --- cue balance) is important.