I need rail bolts, where should I get them?

M

mikeiniowa

AzB Silver Member
Silver Member
I put together my Brunswick Anniversary table and I am short 3 rail bolts and washers and 2 bolts for the pockets.

Any idea if I can get these at a lowes or home depot and what size do I need? I really dont want to take them out to bring them in but was hoping somebody would know the sizes. Thanks

Mike Athens
 
Standard off the shelf hardware available anywhere. Rail bolts are 3/8-16 dia. 2" long. Pocket bolts. Are you talking about the corner casting bolts or the pocket screws for the pockets themselves. Corner castings are same diameter as rail but 1 1/4 long. standard washers will work fine
 
If you need something not standard to your local hardware store or want factory spec parts, the best place I've found for Brunswick parts is Classic Billiards. Here's a link directly to their Hardware section:

http://www.classicbilliards.net/html/antiquepooltablepartshardware.html

They also have a separate section for Anniversary parts (counters, castings etc.). Ken is a good guy and has a lot of hard to get stuff. I was missing some slate screws for my GC4 and couldn't find them in any hardware store (3.5", 16 gauge). He had them and shipped them immediately. :thumbup2:

Hope this helps.
 
Last edited:
You must log in or register to reply here.
Back
Top