leather wraps

[bubsbug]

Does any one have any cheep leather wraps that they want to sell cheep. These are only for practive as I have never done so before. I think I have a good grasp on how to do it. I have even picked up some trade secrets from watching a few of you pros.

Also my ryobi router for a tapershaper has bit the dust I believe. There is play where the collet goes in. I can actually wiggle it back in forth with my fingers. sometimes while cutting it bites maybe .05-.010 and I get a slight offset. Anyone have any comprable replacement ideas. Kress is out of my budget. I do have 4 bosch's though at 1hp but then I would have to have a new bracket made.

 

[cueman]

Does any one have any cheep leather wraps that they want to sell cheep. These are only for practive as I have never done so before. I think I have a good grasp on how to do it. I have even picked up some trade secrets from watching a few of you pros.

Also my ryobi router for a tapershaper has bit the dust I believe. There is play where the collet goes in. I can actually wiggle it back in forth with my fingers. sometimes while cutting it bites maybe .05-.010 and I get a slight offset. Anyone have any comprable replacement ideas. Kress is out of my budget. I do have 4 bosch's though at 1hp but then I would have to have a new bracket made.

Ho many of what I call rejects do you want? They have wrinkles or holes in them. I will let you have them for $1 each but supply is limited.

 

[bubsbug]

Ho many of what I call rejects do you want? They have wrinkles or holes in them. I will let you have them for $1 each but supply is limited.

I think 10 of them would be plenty but I will accept what ever you have available . I just want to practice a few times before I attempt the real thing. Are there any concern that I need to know before doing. Thanks a Bunch.

 

[ddcuerepair]

Also my ryobi router for a tapershaper has bit the dust I believe. There is play where the collet goes in. I can actually wiggle it back in forth with my fingers. sometimes while cutting it bites maybe .05-.010 and I get a slight offset. Anyone have any comprable replacement ideas. Kress is out of my budget. I do have 4 bosch's though at 1hp but then I would have to have a new bracket made.


You may just need to replace the bearings in the housing. They do wear out as they are not made to run as hard as we run them. They would last a lifetime if they were used for what they were made for.