Leon Sly 4 point Ebony!

[Jase0ne]

Hey guys, here’s a very nice Leon Sly Custom pool cue. This cue is a 4 point Ebony with Blue veneers, the butt sleeve is also ebony with a nice white scallop Black Bore inspired designed butt cap! White fancy ringwork above and below the joint! The cue is great condition, but is used, and has a few markings on the butt sleeve and one of the shaft joint collars( please see detailed pictures ). Otherwise the cue’s finish still shines and reflects like glass!
Everything rolls straight, together and apart.

Here’s are the additional specs:
Butt Weight: 15oz
Shafts: *12.65mm @ 3.6oz
*12.75mm @ 3.7oz
Joint Pin: Radial (brass)
Length: 58” (29in/29in split)

Feel free to contact me with any further questions. Thanks! Jason
818.253.I6I7(text available)

Asking $1700 or best offers!

***NO-TRADES

 

[tykcarp57]

damn i wish this beauty was a 3/8x10

 

[Jase0ne]

damn i wish this beauty was a 3/8x10

Just take your 3/8-10 shafts to any qualified cue maker, have them put on the radial tap driver on the right side of the lathe, while your 3/8-10 is mounted on the chuck…. slide right side tap into the shaft opening and manually turn the chuck as you insert the radial tap to recieve it, … screw it all the way into the shaft…. Then Back out the tap and WALA! Your 3/8-10 shaft now is tapped to use accept both 3/8-8 radial and 3/8-10 pins! All my 3/8-10 shafts are set up this way and work fine with no issues or sloppy play.

 

[tykcarp57]

Damn you...