Looking For Female Driver to Fit Kikel

HoldemRw

HoldemRw

AzB Silver Member
Silver Member
Hello my 3/8 10 pins and drivers I have will not fit my Kikel cue. The male end will thread into the shaft but the female end will not screw onto the pin. I was wondering if somebody knew where I could get one or if someone had one for sale.
 
Is his pin a ACME thread? Post a pic? If so, pm me your address and I can send you a delrin JP that will work for you. I have a tap for them.
Dave
 
Can you modify the minor dimension on the arbor? I don't know what pin Kikel uses but my guess is it's a flat minor and that's why it won't fit. Just bore the minor diameter to match the pin. Or better yet make one that matches out of delrin so your not tearing up the one you have. I did something similar to set pins during install.

Sent from my XT901 using Tapatalk 2
 
I believe he uses a 3/8x10 ACME pin which is almost a square thread. Alton just made some jp's for one recently and posted a picture of the pin threads. I have a tap that corrected the issue.
Dave
 
I don't have the Kikel to take a pic but I think they call it a 3/8x10 fat boy pin. That's an expression I heard anyways. If somebody can make me one or has one for sale pm me.
 
You must log in or register to reply here.
Back
Top