LP cue full splice wrapless F/S

Denny

Four Arms
Silver Member
Rosewood into BEM with flame veneers. Ivory joint 3/8x10 pin. Brown collars with silver ring. Ivory ferulles w/med. Morri tips. Abalone dots at the bottom of each point and stack veneers at Delrin butt cap that matches the point veneers. Comes with matching JP's.

Butt: 14.7 oz
Shaft 1: 13 mm 4.1 oz
Shaft 2: 12.75 mm 3.6 oz

SOLD

Thanks Denny
 

Attachments

  • DSC02986.JPG
    DSC02986.JPG
    53.2 KB · Views: 1,496
  • DSC02987.JPG
    DSC02987.JPG
    56.4 KB · Views: 1,478
  • DSC02985.JPG
    DSC02985.JPG
    56.9 KB · Views: 1,478
Last edited:
That is a lot of ivory for 5hundo! If it wasn't the freggn twilight zone lately this cue would probably sell fast....sick part is..
 
I think it's an LP custom by Lee Peppers...and a real looker as well. I bet it hits nice. Good luck with the sale.
 
Yes, I just realized it was Peppers cue. OP, do you have a closer pic of the points? Are they even? And again, does he make his own blanks?

Todd
 
Yes, I just realized it was Peppers cue. OP, do you have a closer pic of the points? Are they even? And again, does he make his own blanks?

Todd

This is a blank I got from Duc Lam.
It's one of my first cues, not sure the number.
If you have any more questions about the construction of this cue, it might be better if you ask the builder.
Thanks
Lee
 
Last edited:
That cue is so pretty, 2 shafts, and joint protectores, I think you should raise the price . Thats to cheep for one of Lee's cues. G/L hold you price. Jim
 
Rosewood into BEM with flame veneers. Ivory joint 3/8x10 pin. Brown collars with silver ring. Ivory ferulles w/med. Morri tips. Abalone dots at the bottom of each point and stack veneers at Delrin butt cap that matches the point veneers. Comes with matching JP's.

Butt: 14.7 oz
Shaft 1: 13 mm 4.1 oz
Shaft 2: 12.75 mm 3.6 oz

$400. + SHIPPING. Would also work out a trade for a Scotty Cameron Button Back putter.



Thanks Denny
Sent you a PM I will take it. Sent you my info.:thumbup:
Bob
 
Back
Top