Sold McDermott “My Michelle” D8 Bar Beater

[Shooter08]

Better than a sneaky, put a rubber band on it for a case and keep it in your trunk. (Trunk storage not advised in extreme temp change environments)
D8 model made from 1984-1990. Butt cap has several chips and some dings and is inscribed Michelle. Forearm has a couple bumps but no cracks or chips in finish. Butt 16.4 straight, shaft 3.6 slight lift when rolled, should not effect play. 195 shipped obo.

 

[Prison break]

i loxe the Michelle scribble , that's so cool
glws

 

[smiling_Hans]

$50 shipped and I will keep the tradition and use it. ROFL

 

[Shooter08]

$50 shipped and I will keep the tradition and use it.

Already had higher offers for the butt alone. Thanks Hans

 

[Mensabum]

Already had higher offers for the butt alone. Thanks Hans

Length?? Shaft mm??

 

[Shooter08]

I will have to measure and caliper in the morning. I would think 58” and close to 13mm.

 

[Mensabum]

I will have to measure and caliper in the morning. I would think 58” and close to 13mm.

Close enuf my friend.
Don't go to all that trouble.

 

[miramachine]

Better than a sneaky, put a rubber band on it for a case and keep it in your trunk. (Trunk storage not advised in extreme temp change environments)
D8 model made from 1984-1990. Butt cap has several chips and some dings and is inscribed Michelle. Forearm has a couple bumps but no cracks or chips in finish. Butt 16.4 straight, shaft 3.6 slight lift when rolled, should not effect play. 195 shipped obo.

Can you confirm that this is a 3/8-10 pin?

 

[Shooter08]

Can you confirm that this is a 3/8-10 pin?

Yes it is.

 

[miramachine]

Yes it is.

I will take it for $150 shipped to Canada