Up for grabs are these two cues. I also have a predator shaft and possibly another cue to post later, but if interested in predator shaft send me a pm. Stats are as follows. (All shaft diameter measurements are at the base of the ferrules).
Mcdermott RS-1. 3/8x10 Stainless Steel pin. Great condition. $400 obo
* Butt: 15.2 oz, 29 inch
* Shaft 1 (original shaft): 3.4 oz, 12.42 mm, 1 inch ferrule, I. think its a Moori medium tip.
* Shaft 2: 3.3 oz, 10.85 mm, 1.25 inch ferrule, elkmaster tip.
OB Break cue. Great condition $225 obo
* Butt: 14.8 oz
* Shaft: 3.9 oz, 12.77 mm, Samsara break tip
When I first purchased and received the break cue, the old owner wasn't for sure that the butt of the cue was made by OB cues, because it didn't have either the silver dash rings, or the laminated wood ring on the bottom of the butt. An OB representative was in town and we looked at it. We took the rubber butt cap off the bottom, and there was the laminated maple core that resembles OB shafts. They informed me that it was one of the first ones built before they started production. Just an FYI in case someone started asking questions.
Thanks
Mcdermott RS-1. 3/8x10 Stainless Steel pin. Great condition. $400 obo
* Butt: 15.2 oz, 29 inch
* Shaft 1 (original shaft): 3.4 oz, 12.42 mm, 1 inch ferrule, I. think its a Moori medium tip.
* Shaft 2: 3.3 oz, 10.85 mm, 1.25 inch ferrule, elkmaster tip.
OB Break cue. Great condition $225 obo
* Butt: 14.8 oz
* Shaft: 3.9 oz, 12.77 mm, Samsara break tip
When I first purchased and received the break cue, the old owner wasn't for sure that the butt of the cue was made by OB cues, because it didn't have either the silver dash rings, or the laminated wood ring on the bottom of the butt. An OB representative was in town and we looked at it. We took the rubber butt cap off the bottom, and there was the laminated maple core that resembles OB shafts. They informed me that it was one of the first ones built before they started production. Just an FYI in case someone started asking questions.
Thanks