Measurement of Joint?

gcgaryyoyo

AzB Silver Member
Silver Member
Hi all, I'm thinking about ordering a new shaft for my cue, and during the email with the cue maker he asked me to go to local cueman or machinist to have my joint diameter and length of the collar figured out. If I go to a machinist how should I tell him to do this for me? I mean I'm not totally sure about where these two parts are-----joint diameter is just the diameter of the joint, where the thread is at right? And the collar length is? Any help is appreciated.:)
 
gcgaryyoyo said:
Hi all, I'm thinking about ordering a new shaft for my cue, and during the email with the cue maker he asked me to go to local cueman or machinist to have my joint diameter and length of the collar figured out. If I go to a machinist how should I tell him to do this for me? I mean I'm not totally sure about where these two parts are-----joint diameter is just the diameter of the joint, where the thread is at right? And the collar length is? Any help is appreciated.:)
Joint diameter is the outside diameter of the end of the joint--he needs to know this so the shafts joint will be the same diameter. This will typically be measured in thousanths of an inch, should be somewhere around 840-850 thousanths. The collar is the black(usually) plastic ring on your old shaft, the butt of the cue should have one of the same thickness. If that ring was a plastic tube- how thick of a piece needs cut off?
 
gmcole said:
Joint diameter is the outside diameter of the end of the joint--he needs to know this so the shafts joint will be the same diameter. This will typically be measured in thousanths of an inch, should be somewhere around 840-850 thousanths. The collar is the black(usually) plastic ring on your old shaft, the butt of the cue should have one of the same thickness. If that ring was a plastic tube- how thick of a piece needs cut off?

I don't get this part, can you kind of reword it for me please:( ?
 
Just an idea

The best idea is to send your cue to the cuemaker! Then he can take whatever measurements are important to be sure the joint and joint collars match up with the shaft. Best of luck....just my 3 cents ;)
 
On your shaft dose it have a black or brown collar on it ?
If so you want to mesure how wide it is along the length of the shaft.
The joint O/D already gives him how thick it is.
 
RayDM said:
I would send both butt and shaft to the cuemaker , so he can copy the shaft collar.

JMO

Ray
Ray and Ken both hit the nail on the head. If you want it perfect, send the cue to the cuemaker. Especially to match the collar color...lots of shades of phenlic out there.

Felt
 
Thank you all. Well I don't intend to send the butt to the cuemaker because for one there's little ring work to do, and for two I'm probably gonna keep this new shaft for my future cues so I'm not really worried about "perfect fit" on my current butt; it's fine as long as it's not visibly far off.
 
Last edited:
Back
Top